How to Connect BMW EDC16C1 by FoxFlash via CAN-Line?
Question: FoxFlash can't connect to EDC16C1 ecu, pinout according to instructions on software, I tried on 3 different ones with no result. Some solutions?
Here is the Possible Reason:
Different HW version.
Pinout on FoxFlash could work for other C1 versions but not for this one.
Solution:
1.Check connection and power supply
Pinout (K-Line):
*Watch white cable because there is also a white/red cable in package.
If error remains,
2.Try Pinout (with CAN-Line)
PIN1&7 -- 12V
PIN2 -- GND
PIN8 -- Kline
PIN46 -- CanH
PIN33 -- CanL
Connect it on Bench Mode.
If error remains, remove Bench Box,
and connect to device on OBD Mode using GT100 Breakout Box + an extra power supply
