Notice:Pls install it on XP system and a clean computer!
Please check the attachment:
Multi-Di@g-Access-J2534-VCI-serial-number-setting.pdf
J2534 setup instruction vedio:
//www.youtube.com/watch?v=50CRK99IC3Q
how to connect the cables?
if you don't know how to connect the cables ,pls see the following diagram:
Multi Di@g Access J2534 VCI serial number
During installation, when Multi-Di@g configuration window appears, you should set
Communication interface to USB and set VCI serial number to A070026:
After installation, MultiDiag shows message asking to get activation code:
Press green button and you will see window asking for code. Please contact us with the code (18-...)
we will send you back the correct password to enter:
During the diagnostic with the device connected, warning about 0 days left will appear. Just check
the mark “Do not display this message again” and continue the work, everything will be working
ok.
Q: Do i need password when using Multi-Diag?
A: Yes. When you install the software,it will give you a code.Please send this code to chinauobd2@gmail.com we will send you activation code.Please be sure to set the VCI to A070026.
Q: Is that necessay to use that COM cable?
A: It is not necessay to use that COM cable, you can diectly use usb cable to connect.
Any questions, please don't hesitate to contact us.
Email:sales02@CarDiagTool.co.uk
Skype:CarDiagTool.co.uk
Yahoo:cardiag.service@yahoo.com
Phone:86-13476108995